Shaft seals - Inch sizes | Shaft Seals

Product code	Product name	Price	Unit
80616001500	A 6,35 X 19,05 X 6,35 NBR	10,00	Pcs
80616002000	A 7,93 X 19,05 X 6,35 NBR	10,00	Pcs
80616002400	MZV 9,52 X 15,87 X 3,17 NBR	24,72	Pcs
80616002500	A 9,52 X 19,05 X 6,35 NBR	10,00	Pcs
80616003000	A 9,52 X 22,22 X 6,35 NBR	10,00	Pcs
80616004000	A 11,11 X 25,40 X 6,35 NBR	11,17	Pcs
80616004500	A 12,70 X 22,22 X 6,35 NBR	10,02	Pcs
80616005000	A 12,70 X 25,4 X 6,35 NBR	10,02	Pcs
80616008000	A 12,70 X 28,57 X 6,35 NBR	10,02	Pcs
80616009500	A 12,7 X 28,57 X 6,35 FPM	38,60	Pcs
80616010000	B 14,28 X 25,4 X 6,35 NBR	14,75	Pcs
80616012500	A 14,28 X 28,57 X 9,52 NBR	10,02	St
80616016000	A 15,87 X 25,4 X 6,35 NBR	10,00	St
80616017000	A 15,87 X 28,58 X 6,35 NBR	10,02	Pcs
80616017500	A 15,87 X 28,57 X 9,52 NBR	10,02	Pcs
80616021100	A 15,87 X 31,75 X 6,35 NBR	10,00	Pcs
80616021200	A 15,87 X 31,75 X 7,93 NBR	10,02	Pcs
80616021300	A 15,87 X 34,92 X 7,93 NBR	10,71	Pcs
80616022500	A 17,46 X 28,57 X 6,35 NBR	10,71	Pcs
80616023000	A 17,46 X 31,75 X 6,35 NBR	10,71	Pcs

Shaft

Shaft tolerance: h11

Surface roughness: Ra 0,3 - 0,5 μm plunge grinding

Surface hardness: 40 - 60 HRC

Housing

Tolerance: H8

Installation chamfer: max. 10°, chamfer 2 mm and max. 1/4 of the seal width.

Operating conditions

Pressure: ≤0,5 bar

Temperature: -35°C...+100°C

Surface speed: ≤12 m/s, maximum surface speed when oil lubrication is good and heat created by friction leads out of sealing lip.

≤30 m/s, type AS-PL ...NBR/T (PTFE coated sealing lip)

Maximum surface speed must be reduced approx:

- 1/3 if good grease lubrication

- 1/5 if seal with dust lip

- 1/3 if sealing lip without spring

Material

Nitrile rubber, FPM

Shaft seals - Inch sizes